| Current Ranges |
60 A / 600 A / 6000 A ACRMS |
| Output Sensitivity (AC coupled) |
50 mV /5mV / 0.5mV per A |
| Load Impedance |
100 kOhm minimum |
| Accuracy (at +25°C) |
±1% of range (45 - 65 Hz) |
| Linearity (10% to 100% of range) |
±0.2% of reading |
| Noise |
8mV ACRMS (60 A) 2 mV ACRMS (600/6000A) |
| Frequency Range |
10 Hz to 50 kHz (- 3 dB) |
| Phase Error |
< ±1° (45 - 65Hz), ±10° (at 20 kHz) </td> |
| Position Sensitivity (with cable > 25mm from the coupling) |
±2% of range |
| External field (with cable > 200mm from the head) |
±1% of range |
| Power Supply |
2 x AA MN 1500 LR6 alkaline 400 Hours, low battery indicator or dedicated ext power supply |
| Temperature Coefficient |
±0.08% of reading per C |
| Working Voltage (see Safety Standards section) |
600 V ACRMS or DC |
| Head Cable length-(double insulated) |
| 610mm (24") I6000s Flex-24
915mm (36") I6000s Flex-36 |
|
| |
610mm (24") I6000s Flex-24
915mm (36") I6000s Flex-36 |
| Head Cable Diameter |
|
| |
14.3 mm |
| Head Bend Radius |
|
| |
38.1 mm |
| Cable length (head to electronics) |
|
| |
2 meters |
| Output Connection |
| 0.5 m cable terminated with
safety BNC connector
Supplied with 4mm safety plug
adaptor |
|
| |
0.5 m cable terminated with
safety BNC connector
Supplied with 4mm safety plug
adaptor |
| Operating Temperature Range |
| -20 to +90°C (head)
-20 to +85°C (electronics) |
|
| |
-20 to +90°C (head)
-20 to +85°C (electronics) |
| Storage Temperature Range |
| -40 to +105°C (head)
-20 to +85°C (electronics) |
|
| |
-40 to +105°C (head)
-20 to +85°C (electronics) |
| Operating Humidity |
| 15% to 85% (non condensing) |
|
| |
15% to 85% (non condensing) |
| Weight |
| 180 g (head), 190 g (electronics) |
|
| |
180 g (head), 190 g (electronics) |
| BS EN 61010 |
|
| |
1.4312500000000001 |
| BS EN 61010 |
|
| |
2-032: 2002 |
| BS EN 61010 |
|
| |
031: 2002 |
| 600VRMS, Category III, Pollution Degree 2 |
|
| |
|
| Note |
| Use of the probe on uninsulated conductors is limited to 600 V ACRMS or DC and frequencies below 1 kHz. |
|
| |
Use of the probe on uninsulated conductors is limited to 600 V ACRMS or DC and frequencies below 1 kHz. |
| EMC Standards |
| BS EN 61326 | 1998 +A1, A2, & A3 |
|
| BS EN 61326 |
1998 +A1, A2, & A3 |
