Find a wide selection of Fluke adapters to help connect your DMMs, eliminate stray voltage or connect your equipment to your PC.
To be used with DMMs and Temperature Probes with K-Type Connector
Connect your DMM to a BNC patch cord. Mmale BNC output.
Stray voltage can appear in electrical installations, due to the capacity between wires. This may result in erroneous readings on high impedance meters. The SV225 solves this without compromising...
Ideal for situations when the sensor tip of the 805 Vibration Meter is difficult to access.
Set of 2 adapters. Features a maximum signal voltage and a maximum voltage to ground of 600V rms.
A must-have for work on Asian or European vehicles.
Adapter for Fluke 1736 and 1738 Power Loggers.
Tank Extension Adapter for the 6102, 7102 and 7103 Liquid Bath Calibrators.
Adapter for the Fluke 1532-156 and 1524-156 Thermometers.
22 channel extra connection module. Includes Cold junction compensation for TC measurements. For use with the Hydra Series III.
22 channel extra connection module. Includes Cold junction compensation for TC measurements and accredited calibration. For use with the Hydra Series III.
10 individual, 10 ohm 0.1%, flat shunt resistors that support measurements up to 100mA. Has direct connection to internal channels for current inputs.
Replacement relay card installable by user, calibration not required after installation. For use with the Hydra Series III.
Hydraulic test hose 10,000 psi, 700 bar working pressure test hose that features stainless steel and nylon construction.
For use with the Fluke 6109 and 7109 Series Portable Calibration Baths.