With FlukeView® Forms documenting software, the logging capabilities of handheld test equipment can be used to solve tough problems. You can download the readings from meters into FlukeView® Forms to spot trends and document measurement data.
You can instantly review and compare data from up to 6 different meters* on the same document - providing analysis capabilities that a meter alone can't provide.
FlukeView® Forms comes with an array of standard analysis and reporting forms that get you started on displaying your data in tables, graphs or helpful diagrams. You can leave notes on the forms to draw attention to a particular event*.
Or use the FlukeView® Forms Designer* to customize your reports or add your company logo.
FlukeView® Forms communicates with supported tools fast and easily via an infrared serial interface. The software will automatically recognize your meter and transfer the data without any configuration.
Share or store your data with co-workers or clients - print forms, export to other software programs, or have co-workers and clients down load the free FlukeView® Demo/Reader to view and interact with your captured data.
Using FlukeView® Forms with Multimeters, Thermometers*, MegOhMeters and ProcessMeter™ tools. With the Fluke 189, 1550B, 89 Series-IV, and 53/54 Series-II, you can measure and store hundreds of readings to the meter's internal memory, and then later download the information to FlukeView® Forms. For meters that do not have internal memory, such as the Fluke-187, Fluke-789 and the Fluke-45, you can take interactive readings while connected to your PC with FlukeView® Forms.
FlukeView® Forms also logs events to make analyzing your data easier. This unique method of data recording provides more detailed readings when the input signal changes significantly. The amount of signal change that will trigger an event can be adjusted to fit your specific test situation. The minimum, maximum and average of readings are recorded for each event. Logging sessions can also be configured so that data will be recorded over specific intervals (e.g., every 5 minutes or 30 seconds).
Using FlukeView® Forms with Fluke 1653 Installation tester
Up to 500 test results can be stored in the Fluke 1653 installation tester. The data stored for each measurement consists of the test function, user selectable test conditions and unique references. The results can be uploaded for preparing professional reports. These reports can easily be customized to suit individual requirements as well as compliance with local regulations. Standard formats as well as localized forms for Germany (ZVEH), Austria (ÖVE) and Switzerland (electrosuisse, gem. NIV) are also available.
*Not supported in FlukeView Forms Basic
|Operating system for FVF-SC2 and FVF-Basic||Windows 98 Second Edition, Windows Me, Windows 2000, or Windows XP|
|Minimum PC Hardware||Pentium class or better microprocessor
32 MB RAM
70 MB hard disk space (100 MB to install)
Serial or USB port
Administrator Privileges required to install software on Windows 2000, XP or Windows NT 4.0
|Size||203 x 100 x 50 mm|