Extend the capability of your meters with test leads and probes from Fluke. These accessories are compatible with a wide range of Fluke products including multimeters, clamp meters and more.
For use with the 810 vibration tester and comes in a pack of 10.
A high-frequency probe designed to convert a DC voltmeter with an input impedance of 10 MΩ into a high frequency (100 kHz to 500 Mhz) RF voltmeter. Additionally, it's probe's DC output is...
Set of three (red, gray, black) safety designed insulated alligator clips for use with STL 120 Shielded Test Leads and TL75 Test Leads. Features a nickel-plated steel jaw contact material with a...
Featuring slide-on alligator clips (red, black) for use with TL175, TL71, and TL75 Test Lead Sets. The jaws provide an 8 mm opening and have a CAT IV 600 V, CAT III 1000 V, 10 A rating.
Designed to improve steadiness with rubber overmolded surfaces and finger-hugging curves. For use with TL222 and TL224 test leads.
Designed to improve steadiness in slippery hands, and is for use with TL222 and TL224 test leads. Rubber over-molded surfaces and finger-hugging curves give a comfortable, reliable grip so you can...
Designed to improve steadiness in slippery hands, and is for use with TL222 and TL224 test leads. Rubber over-molded surfaces and finger-hugging curves give a comfortable, reliable grip so you can...
Designed to improve steadiness in slippery hands, and is for use with TL222 and TL224 test leads. Rubber over-molded surfaces and finger-hugging curves give a comfortable, reliable grip so you can...
Comes equipped with one pair (red, black) of flat, right angle design for connecting to bus bars, and CAT III 600 V, 5 A rating, CSA listed. Adjustable collar provides two ranges of jaw openings...
Single probe pierces 0.01 to 0.6" (0.25 to 1.5 mm) insulated wire with a small pin allows self-healing of the insulation, and 1000 V, 10 A maximum.
Ten replacement probe tips for the 500 series battery analyzers. For use with the BTL10, BTL20, and BTL21 test probes.
Designed for use with the 500 Series battery analyzers, this intelligent test probe set is ideal for maintaining, troubleshooting, and performance testing individual storage batteries. With...
For use with the 1735 and 174 and has 24" length of measuring head and a cable length of 79".
We accept these payment methods:
We also accept wire transfers/EFT, cheques and purchase orders on approved credit. Accepted payment methods vary by country.
