We have you covered when it comes to fluke accessory and replacement parts for your test and measurement equipment. Find parts that enhance your equipment or replace an existing one.
This furnace uses Hart's microprocessor-based controller for great stability and setpoint accuracy. It features a rapid cool-down and heat-up time and an RS-232 port for connection to a PC.
With a 25ft extension cable included, this spare sensor kit has a high-accuracy sensor for most 1620A DewK thermo-hygrometers.
Compatible with virtually all models of DewK thermo-hygrometers, this spare sensor is highly accurate.
Replacement Pump Kit for the Fluke 718 Pressure Calibrators.
Multi-hole Insert, 1/16", 1/8", 3/16", 1/4", 3/8", 1/2".
Multi-hole Insert, 2 ea. at 3/16", 1/4", 3/8".
Multi-hole Insert, 6 at 1/4".
Blank Insert for use with Fluke Dry Block Calibrators.
Removable inserts are sized for probes with the named diameter. Use additional inserts to broaden the range of hole sizes available or to back up or replace existing inserts. This insert is...
With a 25ft extension cable included, this spare sensor kit has a standard-accuracy sensor for most 1620A DewK thermo-hygrometers.
Removable inserts are sized for probes with the named diameter. Use additional inserts to broaden the range of hole sizes available or to back up or replace existing inserts. This insert is...
Removable inserts are sized for probes with the named diameter. Use additional inserts to broaden the range of hole sizes available or to back up or replace existing inserts. This insert is...
Removable inserts are sized for probes with the named diameter. Use additional inserts to broaden the range of hole sizes available or to back up or replace existing inserts. This insert is...
Compatible with virtually all models of DewK thermo-hygrometers, this spare sensor comes as a standard-accuracy version.
Insert A for 9103 Dry Block Temperature Calibrator. Insert A handles a full range of probe sizes with a single well of each size (1/16", 1/8", 3/16", 1/4", 3/8", 1/2").
Insert B features two wells each of 3/8", 1/4", and 3/16" in diameter for doing comparison calibrations.
Insert C has 4 x 1/4" (6.35 mm) diameter wells for multiple probe calibrations.
Insert D has three pairs of metric sized wells.
This replacement fuse is designed for use with multimeters.
If you have a non-standard application that requires custom diameter holes in your insert start with these blank inserts and create your own. This insert is designed for use with the 9141 Field...
We accept these payment methods:
We also accept wire transfers/EFT, cheques and purchase orders on approved credit. Accepted payment methods vary by country.
