We have you covered when it comes to fluke accessory and replacement parts for your test and measurement equipment. Find parts that enhance your equipment or replace an existing one.
This replacement fuse is designed for use with multimeters.
Pump assembly only for Fluke 719 Pressure Calibrator.
This fuse pack is intended for use as an accessory for the SMFT-1000 PV tester.
Sun Visor for the Fluke Ti200, Ti300 and Ti400 Thermal Imaging Cameras.
If you have a non-standard application that requires custom diameter holes in your insert start with these blank inserts and create your own. This insert is designed for use with the 9141 Field...
Removable inserts are sized for probes with the named diameter. Use additional inserts to broaden the range of hole sizes available or to back up or replace existing inserts. This insert is...
Removable inserts are sized for probes with the named diameter. Use additional inserts to broaden the range of hole sizes available or to back up or replace existing inserts. This insert is...
Removable inserts are sized for probes with the named diameter. Use additional inserts to broaden the range of hole sizes available or to back up or replace existing inserts. This insert is...
Removable inserts are sized for probes with the named diameter. Use additional inserts to broaden the range of hole sizes available or to back up or replace existing inserts. This insert is...
250V Voltage rating, 630mA Current rating. Pack of 5.
Blank Insert for the Fluke 9140-A-156 Dry Block Temperature Calibrator.
Block Insert replacement for the Fluke 9140-A-156 Dry Block Temperature Calibrator.
Block Inserts for the Fluke 9140-A-156 Dry Block Temperature Calibrator.
Comparison block insert for the Fluke 9140-A-156 Dry Block Temperature Calibrator.
Insert D for the 9103 Dry Block Temperature Calibrator has three pairs of metric sized wells.
Insert A for 9103 Dry Block Temperature Calibrator. Insert A handles a full range of probe sizes with a single well of each size (1/16", 1/8", 3/16", 1/4", 3/8", 1/2").
Insert B features two wells each of 3/8", 1/4", and 3/16" in diameter for doing comparison calibrations.
Insert C has 4 x 1/4" (6.35 mm) diameter wells for multiple probe calibrations.
Insert D has three pairs of metric sized wells.
We accept these payment methods:
We also accept wire transfers/EFT, cheques and purchase orders on approved credit. Accepted payment methods vary by country.
