We have you covered when it comes to fluke accessory and replacement parts for your test and measurement equipment. Find parts that enhance your equipment or replace an existing one.
Insert A for 9103 Dry Block Temperature Calibrator. Insert A handles a full range of probe sizes with a single well of each size (1/16", 1/8", 3/16", 1/4", 3/8", 1/2").
Insert B features two wells each of 3/8", 1/4", and 3/16" in diameter for doing comparison calibrations.
Insert C has 4 x 1/4" (6.35 mm) diameter wells for multiple probe calibrations.
Insert D has three pairs of metric sized wells.
Blank Insert for use with Fluke Dry Block Calibrators.
This furnace uses Hart's microprocessor-based controller for great stability and setpoint accuracy. It features a rapid cool-down and heat-up time and an RS-232 port for connection to a PC.
Sun Visor for the Fluke Ti200, Ti300 and Ti400 Thermal Imaging Cameras.
This fuse pack is intended for use as an accessory for the SMFT-1000 PV tester.
This replacement fuse is designed for use with multimeters.
This replacement fuse is designed for use with multimeters.
This replacement fuse is designed for use with multimeters.
This replacement fuse is designed for use with multimeters.
This replacement fuse is designed for use with multimeters.
This replacement fuse is designed for use with multimeters.
This replacement fuse is designed for use with multimeters.
This replacement fuse is designed for use with multimeters.
This replacement fuse is designed for use with multimeters.
This replacement fuse is designed for use with multimeters.
(P/N 871202) Fust 3A, 600V. QTY 5 per Blister Pack.
250V Voltage rating, 630mA Current rating. Pack of 5.
We accept these payment methods:
We also accept wire transfers/EFT, cheques and purchase orders on approved credit. Accepted payment methods vary by country.
