Find a wide selection of Fluke adapters to help connect your DMMs, eliminate stray voltage or connect your equipment to your PC.
Remove and refit a pressure gauge's pointer both consistently and quickly using this deadweight tester's pointer remover/punch.
For use with Norma series Power Analyzers.
This fine increment weight set is designed for use with select kPa, mPa, bar and kgf/cm2 weight sets.
Thin, flexible probes for use with the 1760 series Energy Logger and Recorders.
This incremental weight set is designed for use with select psi weight sets.
For use with 1760 Energy Logger & TOPAS 2000 Analyzer.
For use with Norma series Power Analyzers.
For use with MDA-500 Motor Drive Analyzer models.
For use with MDA-500 Motor Drive Analyzer models.
Hydraulic test hose 10,000 psi, 700 bar working pressure test hose that features stainless steel and nylon construction.
Connect your DMM to a BNC patch cord. Mmale BNC output.
Set of 2 adapters. Features a maximum signal voltage and a maximum voltage to ground of 600V rms.
Five-piece set for performing 3-pole fall-of-potential testing that measures the ability of the earth ground system or individual electrode to dissipate energy from the site.
Seven-piece set for performing 3- and 4-pole fall-of-potential testing that measures the ability of the earth ground system or individual electrode to dissipate energy from the site.
For use with Fluke 1623-2 and Fluke 1625-2 Ground Testers.
We accept these payment methods:
We also accept wire transfers/EFT, cheques and purchase orders on approved credit. Accepted payment methods vary by country.
