Get more from your tools and increase its ability with a wide selection of Fluke accessories.
Compatible with any temperature measuring instrument that accepts type K thermocouples features a miniature connector input and a cold reference junction compensation. Additionally, this...
A self-contained temperature-to-voltage converter, this probe is designed to provide a direct temperature reading when it is connected to any high impedance DMM capable of 1 mV resolution, and at...
Designed to improve steadiness in slippery hands, and is for use with TL222 and TL224 test leads. Rubber over-molded surfaces and finger-hugging curves give a comfortable, reliable grip so you can...
Comes equipped with one pair (red, black) of flat, right angle design for connecting to bus bars, and CAT III 600 V, 5 A rating, CSA listed. Adjustable collar provides two ranges of jaw openings...
Single probe pierces 0.01 to 0.6" (0.25 to 1.5 mm) insulated wire with a small pin allows self-healing of the insulation, and 1000 V, 10 A maximum.
Connect your DMM to a BNC patch cord. Mmale BNC output.
Designed to hold the T5-1000 and T5-600 Voltage, Continuity and Current Testers, this leather tester carrying case features rugged construction with heavy-duty stitching and reinforced rivets.
For use with 709H Loop Calibrator to log HART data in the field and to upload the HART configuration of up to (20) HART devices.
The Fluke 80i-110s is optimized for accurate reproduction of currents at line frequency up to the 50th harmonic waveform.
Set of three (red, gray, black) safety designed insulated alligator clips for use with STL 120 Shielded Test Leads and TL75 Test Leads. Features a nickel-plated steel jaw contact material with a...
We accept these payment methods:
We also accept wire transfers/EFT, cheques and purchase orders on approved credit. Accepted payment methods vary by country.
